Routed wire for the Visibar and speaker down through the door post, under the carpet (in the wiring raceway) along the passenger side, up through the kick panel and over to where the console will be. (Since I don’t want a hole in the roof or door post, the wires will route through the rear door seal when needed. This will allow the Visibar rig to be unplugged and removed for casual driving, leaving just a short wire stub and plug hanging loose inside the car.) Installed relay under the dash to control the Visibar.

Once this is completed, the components will actually be functional. (In the past, when showing the car, they were in place and looked good. Soon they will be even better!)